company news about Face recognition wing gate installation steps?

The face recognition system installation mainly has two parts: face recognition installation and gate installation. Please read the product installation instructions carefully before installing the face recognition wing gate gate:

Step 1: First, install face recognition on the turnstile. The installation method is as follows:

1. The first hole with a diameter of 48mm is 400mm from the center of the edge of the gate.

2. Unscrew the hex screw on the bottom of the facial recognition device.

3. Install the facial recognition device on the door hole, turn it to a proper angle, and fix the hex screw.

4. Install the ID card reader to the card reader position of the access gate and fix it.

5. Connect the USB cable of the ID card reader to the USB interface of the ID card verification terminal. After the installation is completed, the ID card comparison function can be realized after the power is turned on (the reader driver will be automatically installed at the beginning of the installation, and the reader will be installed after the installation is completed. Open)

Step 2: Install the gate at the channel position, the steps are as follows:

Step 1 of installing the face recognition wing gate: First, determine the installation position of the face recognition wing, and prepare the network cable, communication cable and other materials. National standard cables are recommended.

Step 2 of facial recognition: Determine whether there are dark grooves or wire grooves for wiring, and try to choose wire grooves for wiring to avoid unnecessary waste of resources and installation time. Set the face recognition wing gate

Step 3: According to the gateway installation plan, combine the power supply with the communication line, and pay attention to the tightness of the underground wiring to prevent line corrosion. Set up the face recognition wing gate

Step 4: Connect the gate to the door panel installation diagram, the connecting line connects the entire access gate into one piece, and seal it with glass glue after installation. The fifth step of installing the face recognition wing gate: check whether there are loopholes in the entire line, check whether the wing gate gate is fixed, and check whether the power is normal.